InHand Networks Power Cord - 4 wires power cord, 4 pin molex coneector, X feet (Y meters)

InHand Networks Cable - 26PIN All-in-one Test Cable: P1 and P2 ends: P1 is 26PIN female to VT310; P2 is open end, which requires a 9-48V adaptor (Suitable for engineering environments and indoor tests)

InHand Networks Cable - OBD-II 7PIN All-in-one Cable: P1, P2 & P3: P1 is 26PIN F to VT310; P2 is OBD-II M to vehicle; P3 is ignition signal term. to ignition on/off. (For heavy trucks w/ OBD-II vehicle diag. interfaces & powers VT310 through interfaces)

InHand Networks Cable - OBD-II 26PIN All-in-one Cable: P1, P2, P3 and P4 ends: P1 is 26PIN female to VT310; P2 is OBD-II male to the vehicle; P3 is open end that includes I/O, RS232-1 and 1-Wire; P4 is ignition signal terminal to the ignition on/off

InHand Networks Cable - 20 pin connector to Deustch Black 6 harness, CAN bus cable, 1 CAN bus (3 meters)

InHand Networks Cable - 20 pin connector to Deustch Green 9 connector harness, CAN bus cable, 2 CAN bus (3 meters)

InHand Networks Cable - 20 pin connector to ODB-11 harness, CAN bus cable (3 meters)